СЕТЕВОЙ КАБЕЛЬ с вилками WATTGATE;
Premium Shilded Power Cord, Сечение проводников 3 x 2,5 qmm
Длинна: 2 м

The cables of the ACCUSTIC ARTS® POWER CORD series are of a very
elaborate design and, in many ways, extremely different from standard
power cords. Power cords, when connecting electronic devices, play a
very big role in the transmission of power line noise, which can cause
distortion to audio signals. To avoid these phenomena, there are quite a
few steps that can be taken, for example: shielding.
Shielding is not only being used under the outer covering of the
ACCUSTIC ARTS® POWER CORD FERRITE II but additionally, each of the
three copper conductors are shielded with a very elaborate “Ferrite-Compound”
covering. Due to this absorbing layer over the copper conductor,
the power cord acts like a “low pass”-filter without influencing the low
frequency music signal.
High frequencies are absorbed by the magnetical and dielectrical loss of
the “Ferrite-Compound” covering and transformed into heat. The damping
is proportional to the length of the cord.

POWER CORD FERRITE II highlights
Pure copper strand (99.999 % OFC) with Ferrite-Compound absorbing
layer and high quality EMC shielding foil
Premium quality mains plug: extremely stable housing; very elaborate
and massive contact pin
Premium quality IEC-plug: special audiophile plug from WATTGATE®;
very elaborate contact surfaces for very stable fit
Cross section: 3 x 2.5 mm2
Outside cord diameter: 14 mm
Standard length: 2 m - fully assembled /
additional lengths per 0.5 m add-on
Available with European mains plug and US mains plug (WATTGATE®)
All ACCUSTIC ARTS® cables are “Handmade in Germany“